Look at that mast height [ATTACH] Centre-board was in raised position. The other huge sail boat, anchored nearby, Sir Robert Bayden Powell,...
Your boat looks cool but it will be hot in the sun, will that sun heat warp it? I have repaired small plastic parts using a soldering iron. I...
To my eye, this looks to much like a hotdog. That tall mast was too tall, and that unusual wind storm burst rolled it right over a full 90...
Video news story MSN...
Here it's cut and finished for bottom paint and straight I coat it with that PL rubber glue first, just a thin coat. I also edge laminated a 1/4"...
All the glue I use is this PL poly adhesive, I found it is 100% waterproof. I use the 28oz tube as it is cheaper than the 10 oz tube for what you...
Horsing it over, it is too strong and thick, it was really stiff all together before the cut. I weigh 240 pounds, and me standing on it on edge...
Ok, It is done and decently straight The board cut in half, one had more tension than the other [ATTACH] I screwed the straighter one to the big...
I split it down the middle, took a while to cut with a jig saw. Planning on screwing one side to the flat board I have to straighten it out flat,...
Guys, I can't dig into with anything, its not soft anywhere. It is only for a wormshoe. If I can glue it reasonably straight, I am going to use...
Sure could! Do you dock a boat? Is the shore power GFCI to the boat? Seems to me, the whole idea of a 'ground' wire is purely for human safety...
I have an AC inverter. I can using my DBDT relay switch box use it to power the boat. I have it because, I don't like the idea of running the...
I could see where it begins bending off, Maybe would just have to slice it down that far, then glue the cut end to straighten. I need to take a...
Today, put on another piece of wormshoe. The red one is 7 feet long. The little one to the left unpainted is 30" This straddles the keel repair....
Pic showing what's going on Laid against uncut wood to show the bow-curve Wife stood on one end and I pushed on other, and it simply lifter her...
