Thanks! I'll see if I can get it shipped here fast enough. If not, how do I determine the type of powder used in a particular filler? I can't see...
Thanks for the advice, but raising temps is only going to help so far. It won't make epoxy harden enough for sanding in 1 hour, at least none of...
So you're saying that polyester filler on top of epoxy is fine, as long as that epoxy is scuffed and the fillet has minimum amount of talc? Does...
Hey, thanks for the advice. We do get hot days but cold nights this time of the year, so that probably contributes to 24 hours of wait time. I'll...
Hi, I am rushing a plywood/fiberglass/epoxy boat build that I need to finish as fast as possible. I am at the stage where the boat has been...
Like I said, in my case, GZ is already calculated. What I need is the GM. And GM = GZ / sin(ϕ) doesn't work for ϕ=0° because that leads to...
Because that doesn't work for the large angles of heel, like I explained in my post... That last formula you quoted - in my case, I already know...
Hi, I am currently improving the ship hydrostatics and stability simulation software that I wrote some years back, and I need some advice. As...
Will do, thank you. I didn't visit that place you linked to yet (very long drive), I called them before though, they said their aspen isn't nearly...
Sometimes I'm amazed that I can't find anything in my local google search, I searched for F60 multiple times and nothing showed up, even now after...
Addition to previous post: foam ain't looking too hot either. With this arrangement (200-280mm spacing), the foam comes out to 2.6 kg of...
Thank you, Rumars, these are some really good tips. But like I mentioned before, balsa is not available where I live, only very small pieces...
Yeah, I used that one before, but as far as I remember it didn't provide any special developability tools except for flattening the panels and...
