Mexican Navy visits Dana Point Harbor – The Log http://www.thelog.com/local/mexican-navy-visits-dana-point-harbor/ See above - turns out they...
Today in Dana Pt. CA. (just north of Camp Pendleton marine base). Military or homeland security? Who makes them? Thanks
You can export your Rhino hulls as GF files which is what Autohydro uses. It works fairly well although I go through the sections and check for...
Cruise ships are on tight schedules, docking almost daily, often in ports where multiple cruise ships are doing the same and it makes sense for...
The Rulefinder website which contains access to all the relevant ISO Standards for CE certification now has a monthly plan that won't break the...
Keep in mind that your repower may require that emission standards be met depending where you are in the world .
http://www.ntsb.gov/investigations/AccidentReports/Reports/MAB1514.pdf
Also check Lynda.com (I have no affiliation). They have a lot of Rhino tutorials that while not marine oriented, will get you up and running in a...
National Marine Manufacturing Association (NMMA) sounds like a logical new home except that 45% of the students are outside the US (per the...
ATHVAS This is the section of this forum where most people post Autoship/Autohydro questions. There are some sharp people here that will...
To rid yourself of half the problems, only model half the hull (assuming you have a boat that is symmetric about the center plane). Unless you...
I'm working with a vendor who insists that on a twin installation the left turning prop should have right hand threads and the right turning prop...
505's are great boats and should you get the chance to sail one you will quickly understand why other posters are discouraging turning it into a...
Although theoretically more efficient, I would be reluctant to put a 2-blade prop behind that massive deadwood. I could result in a good deal of...
Any update on the release of the version?
Why would you use your hand to drive a nail when you can use a hammer? Nesting software is just a tool, like any tool, and if it does a good...
Taniwha, For an Australian builders plate for small recreational craft, Australia allows the use of ABYC, ISO Standards, or Australian AS1799....
And you have to let the guys in the shop glue it up . . . you will take too much time and do too good a job.
Michael is correct - it is a washer plate. The hull was lifted, holes drilled through the bottom of the FRP stub, and the hull was lowered onto...
You're looking down at the top of a steel washer plate that went into the FRP hull. Between the washer plate and the top of the lead keel is the...
